Price: 24,79€
(as of Oct 11, 2024 18:07:05 UTC – Details)
Descripción del producto
Características
Interruptor de flujo de agua
El interruptor de flujo de la bomba de refuerzo de tuberías lleva a cabo un control de encendido y apagado sobre los elementos de detección a través de un dispositivo de control magnético del tipo de flujo de agua, logrando así los efectos de iniciar y apagar las bombas de agua.Este interruptor de flujo de agua es para proteger el tubo láser de CO2. Cuando la bomba de agua no funciona, el sensor de agua detectará y apagará la máquina láser. Por lo tanto, el tubo láser no se romperá.
Ventajas Se puede utilizar con una bomba de agua. En lugar de un enfriador de agua. Elevación: 3,2 m, Flujo: 3000L/H Para tubo láser de 40w/60w/80w Para las Boquillas de Agua, Calibre: 8/10/12mm Cómo lograr los efectos de encender y apagar las bombas de agua.
Tamaño del producto (HT-30)
Estructura del producto
Technical Parameter
Product model HY-30 Medium pressure <0.6Mpa Medium temperature <70° DC 0-110V Current 0.2A Thread G 3/4‘’-3/4” Lift 3.2m Flow 3000L/H Application For 40w/60w/80w laser tube
Diagrama de cableado
Nota
Corte los extremos del extremo del cable y conéctelos a los puertos WP y G de la fuente de alimentación o del controlador (independientemente de si es positivo o negativo)
Lista de empaque
Los conectores y las arandelas son opcionales.
El interruptor de flujo de la bomba de refuerzo de tubería realiza un control de encendido y apagado sobre los elementos sensores a través de un dispositivo de control magnético del tipo de flujo de agua, logrando así los efectos de encender y apagar las bombas de agua.
Este interruptor de flujo de agua es para proteger el tubo láser de CO2. Cuando la bomba de agua no está funcionando, el sensor de agua detectará y apagará la máquina láser. Para que el tubo láser no se rompa.
Se puede usar con una bomba de agua, REEMPLAZANDO el enfriador de agua.
Elevación: 3,2 m, flujo: 3000L / H, para tubo láser de 40w / 60w / 80w.
Para las boquillas de agua, calibre: 8 mm
Angela Hornback –
Easy to I stall and works great. Will nt let me run my laser with out water on.
Dean M. –
Make sure you purchase the 10mm, they work perfectly with the tubing in the Laser machine already. My original sensor was leaking extremely bad. I don’t see any way this could cause a leak in the future. Pretty simple change out and worked great (I had to remove the “Y” connector and place this sensor in line on the inlet side of the hose before it goes to the laser tube). There is no polarity so you can connect the two wires any which way. Get yourself some 13mm Spring Band Type Hose Clamps and ditch the zip ties! While you’re at it change out the tubing as well with some new Silicone Tubing 8mm ID x 12mm OD.
Alessandro luca –
Buon rapporto qualità prezzo fa bene il suo lavoro
Amazon Customer –
Good for detecting flow to protect pumps if run with contactor.
mgreb –
Installed and works fine. Wish it had standard npt threads than the straight thread, rubber washers that were included. The washers would distort and leak anything more that hand tight. Had to face one of the fittings on a lathe to get the rubber washer to seal.